Publicidad
Idiomas disponibles
Idiomas disponibles
Device-specific additional instructions for nailer
4
Adjusting the tool for the staple length and depth adjustment
The tool needs to be adjusted to accommodate the correct
•
staple leg length. For 18mm long staples screw 1 has to be in
the position as shown in the picture (S on the top). For 22mm
long staples screw 1 has to be turned by 180°. Prior to turning
the adjustment screw 1, the headless screw (2) needs to be
loosened and then retightened after adjustment of screw 1.
To adjust the depth of drive: loosen screw 3 and slide the
•
body 2 up or down. By moving body 2 deeper towards the
magazine 4 the driving depth is increased. After adjustment
tighten screw 3 again
5
Adjustment tightness of clinch
The tightness of clinch of the staple is adjustable by turning
•
disc 1. To turn disc 1 insert an allen key (SW 2.5) into one
radial hole of the disc 1. Turning disc 1 into direction L (marked
on tool) results in less clinched staples. Turning disc 1 into
direction T leads to more clinched staples (see picture below).
6
Loading the magazine
Ensure that nailer and fasteners are compatible (Chap. 1) with
•
each other.
Check fasteners for proper condition.
•
Pull feeder 1 to the back and flip downwards. Fill Staples 2
•
from the back into the magazine. Then turn feeder 1 to the top
and push to the forwards.
7
EU Declaration of conformity
The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
MT – A22
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 7
Publicidad
