Publicidad
Idiomas disponibles
Idiomas disponibles
Call up the internal program
In order to call up the internal program, set DIP-switches No. 9 and 10 to On.
Master/Slave-operation
Connect the master and slave-devices as desribed above and set the DIP-switches accordingly.
Please note: If you wish to change from one operating mode into another, you have to unplug the projector
from the mains and plug it again.
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
DMX-protocol
Control channel 1 - Horizontal movement (Pan) (within 180°)
Push slider up in order to move the mirror horizontally (PAN).
Gradual mirror adjustment from one end of the slider to the other (0-255, 128-center). The mirror can be
stopped at any position you wish.
DMX-value
Feature
0-255
Gradual adjustment of the mirror position from left to right
Control channel 2 - Vertical movement (Tilt) (within 90°)
Push slider up in order to move the mirror vertically (TILT).
Gradual mirror adjustment from one end of the slider to the other (0-255, 128-center). The mirror can be
stopped at any position you wish.
DMX-value
Feature
0-255
Gradual adjustment of the mirror position from up to down
Control channel 3 - Colour-wheel
DMX-value
Feature
0-31
Open/white
32-63
Red
64-95
Yellow
96-127
Violet
128-159
Green
160-191
Orange
192-223
Blue
224-255
Pink
Control channel 4 - Gobo-wheel
DMX-value
Feature
0-31
Open
32-63
Gobo 1
64-95
Gobo 2
96-127
Gobo 3
128-159
Gobo 4
160-191
Gobo 5
192-223
Gobo 6
224-255
Gobo 7
29/58
51786025_V_1_4.DOC
Publicidad
