Ameriwood HOME 9100222COM Manual Del Usuario página 24

STEP 16
IMPORTANT: THIS UNIT MUST BE SECURE TO THE WALL TO HELP PREVENT TIPOVER. FOLLOW
THESE INSTRUCTIONS TO INSTALL THE ANTI‐TIPPING SAFETY BRACKET PROVIDED WITH THIS
PRODUCT.
OPTION 1: Attachment into a wall stud
(preferred method)
Using a stud finder, locate a stud in the wall.
Place your unit against the wall, with the
safety bracket aligned in this location. To
make driving the screw easier, you can drill
a 1/8" diameter pilot hole (3mm) through
the safety bracket into the stud. Drive the
screw through the safety bracket into the
wall stud. Tighten the screw that was not
fully tightened in step 5.
OPTION 2: Attachment into drywall
Locate your unit where desired against a
wall and mark the wall through the safety
bracket, then move your unit aside. Drill a
3/16" diameter hole (5mm) into the
wallboard. Tap the wall anchor into the hole
until it is flush. Move your unit into location
and fasten the wall bracket to the wall
anchor with the screw. Tighten the screw
that was not fully tightened in step 5.
12c
12d
(x1)
#A84050
24
For Masonry, Concrete, or other
wall materials:
Consult your local hardware store
for appropriate anchors to securely
attach the safety bracket.
12d
hole
stud
wallboard
12c