Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove the rubber screw covers, the screws, the
hinge cover and the upper hinge from the top
right side of the appliance. See fi gures A and B.
2. Remove the screw hole covers from the top
left side of the appliance and install them in
the screw holes on the top right side of the
appliance. See fi gure C.
3. Remove the solid foot from the lower left side of
the appliance and the adjustable foot and lower
hinge from the lower right side of the appliance.
Swap their positions and reinstall them. See
fi gure D.
4. Remove the actuator from the bottom of the
door and install it on the top of the door. Screw
holes can be found at the top of the door by
gently pulling back the rubber gasket. Before
reinstalling the door on the appliance, it must be
fl ipped 180° from its original position to ensure
that the handle is on the correct side and that the
actuator is at the bottom. See fi gure E.
5. Install the door on the lower hinge and then
install the upper hinge and hinge cover on the
top left side of the appliance. Before tightening
the screws securing the upper hinge, ensure that
the top of the door is level with the top of the
appliance, that the actuator is making contact
with the switch at the bottom of the appliance
and that the rubber gasket is making a good
seal with the appliance all the way around. See
fi gure F.
1. Rubber screw cover
2. Screws
3. Hinge cover
4. Upper hinge
5. Screw hole cover
6. Lower hinge
7. Solid foot
8. Actuator
A
B
C
D
E
F
4
1
2
3
2
4
5
6
2
7
2
8
Publicidad
