cecotec BAMBA PRECISIONCARE 7500 POWER BLADE Manual De Instrucciones página 67

5. Place the comb onto the skin and move the appliance in the
direction of the teeth of the comb.
6. Switch off and clean the appliance after every use.
Trimming with comb
1. Select the stubble comb you wish to use depending on the
size of cut.
2. Click the desired comb into place and make sure it is
correctly fixed.
3. Make sure the comb teeth are pointing upwards.
4. Switch on the appliance.
5. Place the comb onto the skin and move the appliance in the
direction of the teeth of the comb.
6. Switch off and clean the appliance after every use.
7. To remove the comb, hold it from both sides and pull it off
the blade.
Note: Always trim in the direction of the teeth of the comb. This
will give you the best results.
5. CLEANING AND MAINTENANCE
• Clean the appliance after every use.
• Never use compressed air, scouring pads, abrasive
cleaning agents or aggressive liquids such as petrol or
acetone to clean the appliance.
• Do not tap the appliance against a surface to remove water
from it, as this may cause damage. Replace the blade if it
is damaged.
• Remove the comb from the blade. Always turn the
appliance off before putting on or taking off combs
• If a lot of hairs have accumulated on the comb, first blow
them off. Then rinse the comb with lukewarm water.
BAMBA PRECISIONCARE 7500 POWER BLADE
ENGLISH
67