Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE:
is safe must be secured to two
wall studs so it is anchored to the wall studs
in four locations.
Figure 2 shows the installation of the safe in a wood
framed wall (16" centers). For securing the safe to
the wall studs the safe must be a ached to the wood
studs of the wall through the 4 pre-drilled mounting
holes in the safe, with the frame of the safe ush to
the wall surface.
In the gure shown, mount the safe between two
wall studs. Cut a hole in the wall the same size as the
back of the safe. Use ller blocks and bo om
support as required. Mark the 4 hole locations and
drill four 3/16 inch diameter pilot holes. Secure the
safe to the wall studs using 4 lag screws and washers
as shown. (Figure 2)
16"
Figure 2
Filler block
Bottom
support
ACCESSORIES
Use the adhesive backed straps to secure pistols to the
inside of the safe.
e tags can be used to organize
keys.
e le folder is great for storing documents.
MAINTENANCE
Tools Required:
Phillips screwdriver
5mm Allen wrench
If the door of the safe starts to rub on the door
frame, open the door per the instructions above.
By the door hinges you will nd a threaded stem.
Use an Allen Wrench to tighten the threaded stem.
is will realign the door.
IMPORTANT
Keep keys and your combination number in a secure
place, away from children. Keep this record of your serial
number and combination in a secure place separate from
your safe. To order a replacement key set, follow the
instructions on the a ached form.
STACK-ON PRODUCTS CO.
P.O. BOX 489, WAUCONDA, IL 60084
4
18
40537-1505
Publicidad
