Publicidad
Enlaces rápidos
Model / Modelo / Modéle
B66414-6032-WH
Retain these instructions for future use.
Conserve estas instrucciones para usarlas en el futuro.
Conservez ces instructions pour consultation.
www.deltafaucet.com
93504
RP94116
Wall Tape
Cinta de pared
Ruban adhésif
DIRECT-TO-STUD BATHTUB WALL SET
CONJUNTO DE PARED DE TINA
DIRECTA AL MONTANTE
ENSEMBLE MURAL POUR BAIGNOIRE
FIXÉE AUX MONTANTS
1
93504 Rev. B
7/13/2017
Publicidad
Manuales relacionados para Delta B66414-6032-WH
Resumen de contenidos para Delta B66414-6032-WH
- Página 1 CONJUNTO DE PARED DE TINA DIRECTA AL MONTANTE ENSEMBLE MURAL POUR BAIGNOIRE FIXÉE AUX MONTANTS Model / Modelo / Modéle B66414-6032-WH Retain these instructions for future use. Conserve estas instrucciones para usarlas en el futuro. Conservez ces instructions pour consultation. RP94116...
- Página 2 REQUIREMENTS FOR SUCCESSFUL INSTALLATION KNOWLEDGE BASE: Framing Plumbing Tiling These instructions include suggestions for rough construction and plumbing installation. Local building codes vary and could supersede those suggestions. If you are not confident in your ability to perform these tasks, contract out those tasks you need help with or use a professional installer. DO NOT use drywall screws to secure flanges to wall studs.
- Página 3 TOOLS AND MATERIALS REQUIRED • 2 x 4 Lumber for additional wall studs • (8) 1 x 3 x 8' Lumber NOTE: It is recommended to install insulation. HERRAMIENTAS Y MATERIALES NECESARIOS • Tablas de madera de 2 x 4 para montantes adicionales en las paredes •...
- Página 4 Les montants doivent en escuadra. être situés aux endroits montrés sur la figure ci-dessous. Les montants doivent être parfaitement à la verticale et d’équerre. B66414-6032-WH 15 3/8" 14 5/8" 14 5/8" 15 3/8" (39.1 cm) (37.1 cm)
- Página 5 Dry Fit Walls Prepare for Plumbing Fixtures Place drop cloth in bathtub to protect surface while installing walls. Measure and mark location for plumbing fixtures. Place the back wall and side walls into the pocket. Using proper size hole saw, cut out plumbing fixture holes. Check alignment of walls and gaps at seams.
- Página 6 57" (144.78 cm) 1.5" (3.81 cm) 46" (116.84 cm) 12" (30.48 cm) 12" (30.48 cm) Install Back Wood Supports Prepare Back Panel Install horizontal, 57” long 1x3’s on back stud wall as shown. Use 1-1/4" Position back panel as shown, leaving an even gap on both sides of back screws to attach to studs.
- Página 7 Apply Adhesive for Back Panel Install Back Panel Apply double sided tape and polymer sealant/adhesive as shown. Sealant beads should be 3/16” to 1/4” thick. Tape pieces should be approximately 2” long. Press back panel in place. Secure top flanges (1) and screw groove (2) to studs with 1-1/4" panhead or roundhead screws.
- Página 8 28 3/4" (73.03 cm) 46" (116.84 cm) 3/4" (1.91 cm) 12" (30.48 cm) 12" (30.48 cm) Prepare Side Panels Install Side Wood Supports Work with one panel at a time. Drill 3/16" holes at all stud locations on top Install horizontal, 28 3/4” long 1x3’s on side stud walls as shown. Use flanges (1) and screw groove (2).
- Página 9 Apply Adhesive for Side Panels Install Side Panels Working with one side at a time, apply double sided tape and Slide the side panel into gap between wall and back panel, pressing polymer sealant/adhesive as shown. firmly into corner and against studs. Sealant beads should be 3/16”...
- Página 10 Brace Wall Panels Prepare for Tile Install temporary braces (1) to hold back panel tight against studs while polymer sealant cures. Protect surface of wall and tub (2) where it will contact braces. Plan your tile layout so that cut tiles are even at the ends of the tile inlay on the back wall.
- Página 11 Apply Polymer Sealant Install Tile Apply polymer sealant to all seams. IMPORTANT: Allow 24 hours before Using a 3/16" V-notch trowel, spread out the sealant. NOTE: Silicone or acrylic latex sealant exposing to water. is not recommended. Use an advanced Install plumbing fixtures and fittings per If using tile smaller than 1"...
- Página 12 CARE AND CLEANING We recommend that you clean your acrylic bathing product with mild detergents. Use a terry cloth towel, soft cloth, or sponge. Avoid using abrasive scrubbing pads, steel wool, or sponges. After cleaning, rinse thoroughly with water. NOTICE: When using drain cleaner or clog remover, rinse thoroughly with water. NOTICE: Certain chemicals and cleaners may deteriorate the acrylic surface, causing cracks and, potentially, property damage.
- Página 13 LIMITED WARRANTY All All parts and finishes of the Delta® Tub Shower unit are warranted to the original consumer purchaser to be free from defects in material and workmanship for the time periods listed below. Delta recommends using a professional plumber for all installation and repair. Delta will replace, FREE OF CHARGE, during the warranty period, any part or finish that proves defective in material and/or workmanship under normal installation, use and service for the time period listed below: •...
- Página 14 NOTES / NOTAS 93504 Rev. B...
- Página 15 NOTES / NOTAS 93504 Rev. B...
- Página 16 93504 Rev. B...