Avintage AVI60CDZA Manual De Utilización página 46

Temperature display
To view the set temperature in either zone at any time, touch key H and the set temperature will
temporarily flash on the display for 5 seconds. Then the display shows the current inner temperature
again.
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the inner
temperature will not immediately be the temperature shows on the display. Indeed, it is necessary to wait
a few hours for a temperature adjustment of the wine cellar in order to have a homogeneous temperature.
To avoid excessive condensation when the ambient temperature is above 28°C, do not lower the
temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is imperative to
wait 5 minutes before turning it on again.
Temperature alarm
The alarm will sound and the temperature display will flash when:
The temperature in one of the zones rises or falls outside the temperature range (5-12°C or 12-
-
20°C)
You switch the appliance on, if the temperature inside the appliance is very different (+/- 4°C)
-
from the temperature set after 7 hours working
Too many items have been put into the unit at one time, and the temperature inside the appliance
-
is very different (+/- 4°C) from the temperature set after 7 hours working
The door has not been closed tightly
-
Door alarm
If the door has been left open for more than 60s, the alarm will sound. Once the set temperature has
been reached in the appliance, the alarm stops and the relevant temperature display stops flashing.
However, if the noise disturbs you, you can switch the alarm off before this if you wish by pressing the key
I once. The alarm will stop. The relevant temperature display continues to flash until the set temperature
has been reached. The display then lights up constantly and the alarm system is fully active again.
Interior light
The interior light makes it easy to view your wines labels and enhances the display of your collection.
Touching the mark (J) toggles between two modes of operation for the internal lights:
Functional mode (default): the light will turn on only when the door is open, this is the most
-
economic mode
Showcase mode: the lights will be on whether or not the door is open. To turn this permanent light
-
mode and get back the default mode, please push again the light button
Dynamic climate / silent mode
Wine cellars are designed to preserve your wines in perfect conditions over long periods in complete
safety. However, no frost systems can cause noise, this is the reason why the silent mode is the default
factory setting. Thus, you can switch off the silent mode to switch to the ventilated cooling mode by
pressing the key "+" (C) for 5 seconds. The cellar will emit 5 sound signals to confirm the passage in
ventilated cooling mode. Conversely, to deactivate the ventilated cooling mode and return to the default
silent mode, press and hold the key "-" (B) for 5 seconds. The cabinet will emit 3 sound signals to confirm
the silent mode.
Modes
SABBATH MODE
Sabbath mode is available for the observance of certain religious holidays. This mode turns off the
(J).
46