Safety Instructions
The Fuel System:
Gas grills are used safely by millions of people when following simple safety precautions.
The items in the fuel system are designed for operation with this grill. They must not be replaced with any
other brand. (See parts list for replacement items.)
GAS BURNER: The gas burner is constructed of stainless steel and should not require maintenance other
than inspection for insects/nests inside the air intake slots.
LP GAS REGULATOR CAUTION:
The gas pressure regulator provided with this appliance must be used. This regulator is equipped with the
required orifice and is set for the required outlet pressure for this appliance. This combination of orifice size
and pressure regulation specifications provides the cooking performance intended by Nexgrill Tabletop Grill.
Substitution of regulator by any other device or any other manufacturer is dangerous and could result in
serious injury.
PROPANE FUEL: Warning - propane is a flammable gas. Improper handling may result in an explosion
and/or fire and serious accident or injury. Your grill is designed to operate with propane (LP) gas only and is
equipped with the proper orifice for propane gas.
Caution: Do not connect this grill with any gas supply other than propane. Propane gas is heavier than air
and settles in lower areas. Make certain adequate ventilation is available when using your grill. The gas
cylinder may be stored outside in a well-ventilated area out of the reach of children when the grill is not in
use.
The LP gas cylinder shall be used only outdoors in a well-ventilated space and not in a building, garage, or
any other enclosed area. The Nexgrill Tabletop Grill may be stored indoors if the LP gas cylinder is removed
and stored outdoors. The LP gas cylinder (not included) is threaded for connection directly to the gas
regulator supplied with this appliance. Care should be taken when threading the cylinder to the regulator to
engage threads correctly to achieve the proper and intended connection. When disconnecting or connecting
the gas cylinder, be careful that the regulator does not strike the grill, the ground, or any other surfaces.
Replace the protective cap over the threaded cylinder connection when removed from grill. If any difficulty
occurs when connecting or disconnecting the cylinder to the regulator assembly, contact your local gas
supplier for assistance.
When reconnecting the LP gas cylinder to the regulator, be sure to hand-tighten until snug. This connection
should be inspected for damage and leak-tested after each reconnection.
To Do a Leak Test, make a soap solution of one part liquid detergent and one part water. You will need a
spray bottle, brush, or rag to apply the solution to the fitting. Bubbles indicate leaks.
Check all gas supply fittings for leaks before each use. Do not use the grill until all connections have
been checked and do not leak.
4