Homewerks 3010-501-BN-WS Instalación

MOBILE HOME TUB AND
SHOWER KIT
MODEL
3010-501-BN-WS – Brushed nickel finish
PACKAGE AND HARDWARE CONTENTS
PART DESCRIPTION
A Faucet body assembly
Shower head assembly with arm
B
and flange
C Mounting nut
D PTFE tape
SAFETY INFORMATION
Please read and understand this entire manual before attempting to
assemble, operate or install the product.
WARNING
• Protect your eyes with safety glasses when cutting or soldering water
supply lines.
PREPARATION
Before beginning assembly of product, make sure all parts are present.
Compare parts with package contents list and hardware contents. If any
part is missing or damaged, do not attempt to assemble the product.
Contact customer service for replacement parts.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Adjustable Wrench, Groove
Joint Pliers, Pipe Wrench, Phillips Screwdriver, Pipe Tape or Pipe Thread
Compound, Supply Lines
Installations may vary depending on how the previous tub/shower was
installed. Supplies necessary for the installation of the tub/shower are
Homewerks Worldwide, LLC • Lake Bluff, IL 60044 • www.homewerksww.com
QUANTITY
1
1
2
1
B
CAUTION
• If you solder the joints during installation of the tub/shower, the seats,
• Cover the sink drain to avoid losing parts.
not all included; however, they are available wherever plumbing supplies
are sold.
Prior to beginning installation, turn off the hot or cold water lines, then
turn on the old tub/shower to release built-up pressure. When installing
the new tub/shower, hand tighten the connector nuts. DO NOT OVER-
TIGHTEN. Connections that are too tight will reduce the integrity of the
system.
Wrap all threaded connections with PTFE pipe tape available at your local
hardware or plumbing supply store. Always wrap in a clockwise direction.
A
D
cartridges, and washers must be removed before using a flame or
the warranty will be voided on these parts.
C
11-03-2016
C US