Homewerks 3070-250-CH-B-WS Instrucciones De Instalación

Indoor/Outdoor
Utility Shower Kit
MODELS
3070-252-CH-B-WS - Chrome finish
3070-252-BN-B-WS - Brushed nickel finish
3070-252-MB-B-WS - Matte black finish
PACKAGE AND HARDWARE CONTENTS
PART DESCRIPTION
A Showerhead
B Shower arm
C Soap dish
D Mounting screw
E Faucet body
F Drywall anchor
G Thread seal tape
SAFETY INFORMATION
Please read and understand this entire manual before attempting to
assemble, operate or install the product.
WARNING
• Protect your eyes with safety glasses when cutting or soldering water
supply lines.
PREPARATION
Before beginning assembly of product, make sure all parts are present.
Compare parts with package and hardware contents list. If any part is
missing or damaged, do not attempt to assemble the product. Contact
customer service for replacement parts.
Estimated Assembly Time: 30 minutes
Tools Recommended for Assembly (not included): Adjustable Wrench,
Drill, Drill Bits, Slip Joint Pliers, Pipe Wrench, Phillips Screwdriver, Pipe
Compound.
Need Help? Please call our toll-free line at (877) 319-3757 (7:30 a.m. to 4:30 p.m. CST) for additional assistance or service.
Homewerks Worldwide, LLC • Lake Bluff, IL 60044 • Homewerks.com
QUANTITY
1
1
1
4
1
4
1
CAUTION
• If you solder the joints during installation of the shower, the seats,
• Cover the drain to avoid losing parts.
Installation may vary depending on how the previous shower was
installed. Supplies necessary for the installation of the shower are not
all included; however, they are available wherever plumbing supplies
are sold.
Prior to beginning installation, turn off the hot and cold water lines, then
turn on the old shower to release built-up pressure. When installing the
new showerhead, hand tighten the connector nuts. DO NOT
OVERTIGHTEN. Connections that are too tight will reduce the integrity of
the system.
A
C
G
E
cartridges, and washers must be removed before using a flame
or the warranty will be voided on these parts.
B
D
F
12-2021