Publicidad
Idiomas disponibles
Idiomas disponibles
Updating Procedure
Important: The updating function erases all user
settings. We recommend you write down your
settings so that you can easily reset them after
the update. Note that updating the firmware
resets the subwoofer connection too.
1. Connect a Micro USB to USB adapter cable
with a male USB 2.0 Micro USB plug (Type B)
on one end and a standard female 2.0 USB
jack (Type A) on the other end to the micro
USB jack on your Soundbar.
• The Micro USB to USB adapter cable is
sold separately. To purchase, contact a
Samsung Service Center or Samsung
Customer Care.
2. Follow the steps below to download the
product software:
Go to the Samsung website at
(samsung.com) search for the model name
- select the customer support option (the
option name is subject to change)
3. Save the downloaded software to a USB
stick and select "Extract Here" to unzip the
folder.
4. Turn off the Soundbar and connect the USB
stick containing the software update to the
female port on a Micro USB adapter cable.
Connect the cable to the USB port on the
Soundbar.
5. Turn on the Soundbar. Within 3 minutes,
"UPDATE" is displayed and updating begins.
6. When the update finishes, the Soundbar
turns off. Press the p button on the remote
control for 5 seconds. "INIT" appears on the
display and then the Soundbar turns off.
The update is complete.
• This product has a DUAL BOOT function.
If the firmware fails to update, you can
update the firmware again.
7. Reset your settings.
If UPDATE is not displayed
1. Turn off the Soundbar, disconnect and then
reconnect the USB storage device that
contains the update files to the Soundbar's
USB port.
2. Disconnect the Soundbar's power cord,
reconnect it, and then turn on the Soundbar.
NOTES
• The firmware update may not work properly
if audio files supported by the Soundbar are
stored in the USB storage device.
• Do not disconnect the power or remove the
USB device while updates are being applied.
The main unit will turn off automatically after
completing the firmware update.
• After the update is completed, the user setup
in the Soundbar is initialized so you can reset
your settings. We recommend you write
down your settings so that you can easily
reset them after the update. Note that
updating firmware resets the subwoofer
connection too.
If the connection to the subwoofer is not
re-established automatically after the
update, refer to page 6.
If the software update fails, check if the USB
stick is defective.
• Mac OS users should use MS-DOS (FAT) as the
USB format.
• Updating via USB may not be available,
depending on the USB storage device
manufacturer.
ENG - 31
Publicidad
