ICY BOX IB-563SSK Manual página 4

1. Features
• 3x 3.5" SATA or SAS HDD/SSD in 2x 5,25" bay
• Trayless and easy installation
• Aluminum and Stainless Steel
• Intelligent Fan Control (6x6cm fan)
• Audio + LED Alarm for fan failure and overheating
• Individual Power-Switch
• Hard disk capacity not limited
• SATA I/II/III host interface 6.0 Gbit/s
• With key lock to secure the HDDs
• LED for power, HDD access
• Patented NSS SATA/SAS connector supports 50.000 times Hot Swap
2. Packing Content
1x IB-563SSK-B, 3x SATA cables, 2x Keys, 8x Screws, 1x Manual
3. Front & Rear Panel
1 2 3
1. Power Button with LED for power and Access (blue) 1. Power Ports
2. Key Lock
3. Door Handle
4. Installation
1. Remove the cover of an empty drive bay of 2x 5.25" space. Smoothly insert the IB-563SSK into the bay
and push it inwards until its screw hole is aligned with the hole of the bay. Use two screws on each side
to securely hold the device. The installation-direction must beright: Lock at the left side!
2. Connect the SATA 15Pín power cable or Molex 4 Pin to the power supply of your PC. Connect the SATA
7Pin data cable to the connector on the rear side of the IB-563SSK, another end to the SATA 7Pin data
port on the main board (or SATA RAID card) of your PC.
3. Unlock and pull the door puller. Place the HDD (label side up) into the IB-563SSK. Close the door to push
the HDD into the IB-563SSK until the door is locked.
IB-563SSK
1
2. SATA DATA Connector (7pin)
3. LED indicator switch OFF / ON
4. Fan Setting Mode
5. Temperature Alarm Setting
6. Alarm Buzzer
4
2 3 4 5 6