Descargar Imprimir esta página

Glacier bay 20120-0127H2 Guía De Uso Y Cuidado página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
1
Marking the mounting location
Remove the set screw (DD) from the base of the
product posts.
Place the product in the desired mounting
location, using a level to position it accordingly,
and use a pencil to lightly mark the outline of the
posts.
Center the mounting bracket (BB) within the
marked post locations, and mark where the
screw holes will be drilled.
Repeat this step as needed for each bath
accessory.
NOTE: The included template (EE) may be used to mark the
mounting locations for the towel bars and pivoting tissue
holder : A and B for the pivoting tissue holder / A and C for the
18 in. towel bar / A and D for the 24 in. towel bar.
3
Installing the product
Place the post (A or C / E or F) over the mounting
bracket (BB) and secure it with the set
screw (DD), as shown.
Insert the towel bar (B or D) into the installed
post (A or C).
Repeat the first step for the remaining
post (C or A / F or E).
DD
BB
2
Installing the mounting brackets
Drill 1/4 in. holes in the previously marked
locations.
Push the plastic anchors (CC) flush into the dry wall.
Fasten the mounting bracket (BB) to the wall with
the wood screws (AA).
Repeat this step as needed for each bath
accessory.
NOTE: When mounting the products to a wood wall, fasten
the mounting brackets (BB) to the wall using the wood
screws (AA). There will be no need for drilling or plastic
anchors (CC).
A or C / E or F
5
l P
a e
e s
o c
t n
c a
1 t
8 -
5 5
-HD-GLACIER
CC
AA
BB
BB
AA
BB
DD
H
O
M
D E
P E
T O
f
r o
u f
t r
e h
a r
s s
s i
C .
O
M
a t
c n
. e

Publicidad

loading