Part 3
INITIAL STEPS FOR INSTALLING YOUR DRYER
STEP 3 Procedure of Control Panel Change
!
• Disconnect power before servicing.
• Replace all parts and panels before operating.
• Be careful of the sharp edge on frame which makes you hurt.
• Failure to follow these instructions can result in death or electrical shock.
Disassemble
Push the cap on the right side of control
1
panel.
Remove the screw.
Slide the control panel to the right about
an inch.
Control Panel
Push the housing hook and disassemble the
2
panel.
!
WARNING!
Be careful of dropping the control panel.
Housing
Hook
Remove the plate by lifting it up slightly.
3
WARNING!
Frame
Plate
Push the cap on the right side of lower
4
cover.
Remove the screw.
Slide the lower cover to the right about an
inch.
Cap
Assemble
Remove the safety cover.
1
Attach the housing of control panel until it
2
clicks into place.
!
Make sure that the housing is attached correctly.
If not, the dryer may not operate.
Note
LG is not responsible for any damages to your
dryer incurred while a customer is changing.
Lower, Cover
Safety Cover
WARNING!
Frame
Housing
Cap
9