Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
1
Attaching the side handle
□ Attach the side handle (B) to the cabinet using four bolts
(AA).
□
Tighten all bolts with the 10 mm wrench (DD).
Do not over tighten the bolts to avoid damage to the finish.
NOTE: The holes in the cabinet are tapped and do not
require nuts.
3
Installing the crank handle or crank cap
□
Install the crank handle (K) or crank cap (L) into the shaft
next to the Husky badge.
NOTE:
Store the crank handle (K) or crank cap (L) in one of the
drawers when not in use.
□
B
AA
K
2
Installing the casters
Warning: Two or more people may be required for this
step due to the weight of the workbench.
CAUTION: Do not over tighten the screws.
□
Ensure all cabinet drawers are securely locked into
place using the key (I) and lock (J) on the rolling cabinet (C).
□ Lay the rolling cabinet (C) on its back
packaging material to protect the finish.
□ Mount the two swivel casters with brake (D) to the rolling
cabinet (C) using four bolts (CC) and washers (BB) per
caster. The s wivel casters with brake (D) should be
installed on the same side as the side handle (B) .
□ Mount the two swivel casters (G) to the rolling cabinet (C)
using four bolts (CC) and washers (BB) per caster.
□ Tighten all bolts with a 13 mm wrench (DD).
□ Return the rolling cabinet (C) to its upright position.
BB
DD
DD
4
Attaching the power strip brackets
□ Attach the power strip brackets (H) to the cabinet using four
bolts (EE).
□
Tighten all bolts using a screwdriver.
Do not over tighten the bolts to avoid damage to the finish.
NOTE: The holes in the cabinet are tapped and do not
require nuts.
L
6
6
on top of the
G
CC
□
EE
B
C
D
H
Publicidad
