2
FIT AND SECURE
2.13
2.14
FRONT LH
2.15
FAFR004_REV_A01
FRONT RH
BACK LH
BACK RH
10mm
7
Clean the area around the holes in the
vehicle's roof using a rag and denatured
alcohol. Place some silicone around each
hole in the vehicle's roof.
Position the spacers as shown in Fig 1.1 in
the vehicle's ditch, aligning the cut outs in
the spacers with the holes in the vehicle's
roof.
Place some silicone in the cut outs of the
spacers as shown.
Place a bead of silicone on the four nut
plates ( Item 20 & 21 ). This will bond the
nut plates in place, so that the headliner
does not need to be removed in future,
should you want to remove the rack.
Have a friend position & hold the nut
plates inside the car, while you secure the
foot rail to the roof as instructed below.
Place a bead of silicone down the threads
of each bolt before inserting.
Place the Foot Rail (Item 1) onto the
Spacers (Item 2, 3, 4 & 5), aligning the
holes in the base of the Foot Rail with the
center of the Spacers.
Secure the Foot Rail to the vehicle using
the M8x40 Hex Bolts, M8 Spring Washers
& M8x19x2 Flat Washers (Items 8, 9 & 10).
Fully tighten.
Place M8 nut caps (Item 5) over all nyloc
© 2021 FRONT RUNNER VEHICLE OUTFITTERS
13mm