Front Runner FAFR002 Manual De Instrucciones página 3

2 FIT AND SECURE
2.1
2.2
2.3
FAFR001_REV_A01
10mm From Tip Of Drill To Start Of Tape
Starting at the front of the vehicle's roof,
measure and mark the dimensions as
shown onto each of the ditch mouldings.
Remove the two ditch mouldings and cut
on each of your markings. Make sure to
mark the various pieces so that you are
able to place them back onto the vehicle in
their correct positions.
Make the following four markings as
shown in the center of each ditch in the
vehicle's roof.
Before drilling the holes in the roof, take
both 4 & 9 mm drill bits and wrap a band
of insulation tape around the drill bits to
act as a stopper to prevent you from
drilling to deep as there are airbags
located below where you will be drilling.
Drill the 8 holes you marked earlier,
starting with a 4mm pilot hole before
going to the 9mm hole. There is no need
for a lot of downward pressure. Let the
drill do the work.
3
13mm
© 2020 FRONT RUNNER VEHICLE OUTFITTERS