Front Runner KRFE004T Manual De Instrucciones página 3

2
FIT AND SECURE
2.1
2.2
2.3
KRFE004T_REV_A00
Assemble your Slimline II Tray, referring to
the RRSTUNI fitment guide.
Flip the Tray so that the bottom of the Tray
faces up.
Insert eight M8x16 Hex Bolts into the Slats
machined slots as shown.
Insert four M8x30 Hex Bolts into the Slats
machined slots as shown.
Refer to RRSTUNI and fit your Wind Deflector.
Loosely assemble the three Grab On Foot
Sets (Item 3) onto the slats indicated in 2.2
as shown using M8 Flat Washers and M8
Nyloc Nuts.
Note the Spacers must be used on the rear
feet only.
3 © 2020 FRONT RUNNER VEHICLE OUTFITTERS