SHOWJOE iON13SS Manual Del Operador página 13

7. Remove the old auger from the housing (Fig. 18).
Fig. 18
Auger
8. Install the replacement auger by following the above steps
in reverse order (Fig. 19).
Fig. 19
Replacing the Belt
m
WARNING!
Make sure to turn off the switch and
remove the battery before performing any maintenance task
on your cordless snow shovel.
1. Disassemble the left side cover by removing the
five (5) screws that hold it in place (Fig. 12).
2. Remove the old belt from the body by slowly turning the
auger while lifting the belt (Fig. 20).
Fig. 20
3. Replace the worn belt with a new belt (Fig. 21).
Fig. 21
4. Place the left side cover back into position and refasten
the five (5) screws.
Replacing the Scraper Blade
m
WARNING!
remove the battery before performing any maintenance task
on your cordless snow shovel.
1. Turn the snow shovel over. Using a drill, remove the
four (4) screws that secure the scraper blade to the base
of the unit (Fig. 22).
Fig. 22
4 screws
2. Remove the old scraper blade (Fig. 23).
Fig. 23
Belt
Auger
Scraper blade
13
Belt
Make sure to turn off the switch and
Drill