Metra 99-6521B Instrucciones De Instalación página 3

ISO DIN radio provision with pocket
1. Mount the pocket to the radio
brackets with the (4) #8 x 3/8"
Phillips screws supplied. (Figure A)
2. Slide the radio into radio brackets and
secure with the screws supplied with
the radio. (Figure B)
3. Mount the radio/pocket/bracket
assembly into the dash with the
factory hardware.
Note: It may be necessary to
cut the small rear support shelf in
the bottom center of the
radio cavity. (Figure C, shaded area)
4. Locate the factory wiring harness
and antenna plug in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
5. Secure the radio trim panel into
the dash over the new radio and
reassemble dash in reverse order
of disassembly.
Kit Assembly
(Figure A)
99-6521B
(Figure B)
3
(Figure C)