LEITZ ProfiCut Manual De Instrucciones página 23

In order to keep the diameter and profile of the profile knives constant,
resharpening must be carried out by the Leitz Sharpening Service.
Risk of breakage and loss of accuracy due to non-compliance!
ProfilCut Q Diamond
ProfilCut Q Diamond - The profile knives are PCD-tipped and they can't be reground at the
cutting area but only at the clearance face.
If required, the profile knives can be reground in the Leitz service stations up to 5 times
(0.3 mm per sharpening cycle, i.e. maximal 1,5 mm).
WP8
Turnblades and spurs are not allowed to be resharpened!
Risk of breakage and loss of accuracy!
11/2019 ID.524811 V3.0 23