Axis P1354-E Guia De Instalacion página 20

AXIS P13-E Series
Install the Camera on the Bracket
Note
To locate the different components see illustrations under Hardware Overview on page 10.
1
Axis network camera
2
Network cable (route through wall bracket)
3
Cable holes
4
Bracket screw (4x)
5
Cable cover
6
Cable cover screw (2x)
7
Wall bracket
8
Bracket adjustment screw
1. Install the camera with the bottom cover on the bracket and tighten the bracket screws.
2. Remove the gasket from one of the holes in the bottom cover.
3. Route the network cable through the hole and plug the cable gasket to the hole.
4. Connect the cables, see Connect the Cables.
5. Take the top cover and attach the safety wire to the tab on the bottom cover.
6. Loosen the bracket adjustment screw to point the camera in the right direction. See
page 22 for information on how to view the video stream.
Adjust the focus, see page 23.
20