Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
3
Installing the Door Pulls
□ Place a door pull (BB) over the pre-drilled holes on the right
door and secure to the door using the included bolts.
□ Repeat for remaining door pull (BB).
4
Adjusting the Levelers
NOTE: Clean area where the cabinet will be permanently
located prior to beginning installation, ensuring the cabinet
will not interfere with any water supply and drain lines
once mounted.
□ Find and mark locations of wall studs behind the
permanent location of cabinet.
□ With two people, carefully place cabinet (A) against the
wall in its final location. While holding the cabinet base
firmly against the wall, use the pre-assembled levelers on
the bottom of each leg of the cabinet (A) to level the item.
Twisting the levelers counterclockwise will raise the height
of the cabinet (A), and twisting them clockwise will lower
the cabinet.
□ Once the cabinet is in place, against the wall, and level
from front to back and side to side, drill a hole through the
cabinet mounting area and into the wall studs (as illustrated
in diagram). Using appropriate mounting hardware (not
included), secure the cabinet (A) to a wall stud. If possible,
secure the cabinet (A) to two wall studs for increased stability.
BB
WARNING:
□ Cabinet MUST be secured to wall studs.
7
Please contact 1-855-HD-GLACIER for further assistance.
HOMEDEPOT.COM/GLACIERBAY
Publicidad
