Linea 2000 Domo DO91101 Manual De Instrucciones página 33

Idiomas disponibles

INSTALLATION

Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth and the

inside with a wet, lukewarm cloth. Dry the appliance off well.

Do not tilt the refrigerator more than 45° when moving it. Do not apply force to any part such as the

door and its handle in order to prevent the refrigerator from deforming, or else its performance will be

influenced.

Let air circulate freely around the cabinet.

This cooling unit is not intended for use as a built-in appliance.

Select a place with a strong, level floor.

Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will

cause higher electricity consumption.

Avoid very moist places. Too much moisture in the air will cause frost to form very quickly on the

evaporator, and your refrigerator.

Before connecting your refrigerator to the power supply, check that the voltage stated on the rating

label of your appliance corresponds to the voltage in your home. A different voltage could damage the

appliance.

After installation, leave the refrigerator for 24 hours before turning it on. This way the refrigerant can

settle.

Allow the appliance to run empty for 8 hours so the compartment can cool to the appropriate

temperature.

One can level the appliance using the adjustable legs. The adjustable legs can be adjusted by screwing

them in or out of the appliance.

The climate class indicates the minimum and maximum ambient temperature for the proper operation

of an appliance. You can find the climate class on the type plate on the back of the appliance.

SN: Subnormal: ambient temperature between 10°C and 32°C

N: Normal: ambient temperature between 16°C and 32°C

www.domo-elektro.be

Lift

Lower

DO91101