Poulan Pro PR25PS Manual De Instrucciones

BAR AND CHAIN LUBRICATION
Add bar and chain oil to oil tank until full.
STARTING A COLD ENGINE
NOTE: DO NOT squeeze the throttle trigger until the engine has
started and runs.
1. Set unit on a flat surface.
2. Slowly press the primer bulb (A) 6 times.
3. Move the start lever (B) to the START position.
4. Pull starter rope handle (C) sharply until engine starts and runs.
5. Allow unit to run for 10-15 seconds, then fully squeeze the
throttle trigger (D) to disengage the starting system.
STARTING A WARM ENGINE
1. Squeeze and hold the throttle trigger.
2. Pull starter rope sharply while squeezing
throttle trigger until engine runs.
HOW TO STOP YOUR UNIT
1. Release the throttle trigger.
2. Push and release the engine ON/STOP
switch (E).
The switch will automatically return
to the ON position. Wait 5 seconds
before attempting to restart unit to allow switch to reset.
115828649 Rev. A 2016-05-04
FUELING THE ENGINE
Mix 2.6 oz. of full synthetic 2-Cycle Oil with 1 gallon of gasoline for a 50:1
mixture. Shake well. Pour into fuel tank.
CAUTION: Do not use alternate fuels such as ethanol blends above 10%
by volume (E-15, E-85) or any methanol blended fuel.
E
D
PR25PS
A
B
C
RS25CSPR