Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Green LED is flashing
and the display shows
CHARGE ABORTED-
BAD BATTERY.
The display shows
CONNECT CLAMPS.
16. SPECIFICATIONS
Input Voltage ................................................................120V AC @ 60Hz, 0.91A
Output Voltage .......................................6V or 12V, with Auto Voltage Detection
Output Current Rating ..........................................................2A @ 6V; 3A @12V
17. REPLACEMENT PARTS
Battery clamps (quick-connect) ..................................................... 3899002636Z
Ring connectors (quick-connect) .................................................. 2299002042Z
12V accessory plug (quick-connect) ............................................. 3899001401Z
18. BEFORE RETURNING FOR REPAIRS
For REPAIR OR RETURN, contact Customer Service at 1-800-621-5485. DO
NOT SHIP UNIT until you receive a RETURN MERCHANDISE AUTHORIZATION
(RMA) number from Customer Service at Schumacher Electric Corporation.
POSSIBLE CAUSE
The battery is bad.
The battery is too large for the
charger.
The clamps are not making a good
connection.
The fuse is bad.
For information about troubleshooting,
contact customer service for assistance:
services@schumacherelectric.com
www.batterychargers.com
or call 1-800-621-5485
• 14 •
SOLUTION
Disconnect charger from the
AC outlet and then remove the
clamps. Do not continue to try
to charge the battery. Have the
battery checked or replaced.
You need a charger with a higher
amp rate.
Check for poor connection at
battery and frame.
Replace the in-line fuse for the
ring connector.
Publicidad
