Descargar Imprimir esta página

Bosch EasyAquatak 110 Manual Original página 12

Ocultar thumbs Ver también para EasyAquatak 110:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
OBJ_BUCH-2949-002.book Page 12 Monday, August 7, 2017 2:55 PM
12 | English
We recommend that this equipment
is only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA residu-
al current.
Remove the plug from socket when-
ever the machine is left unattended
for any period.
The electric supply installation
should comply with IEC 60364-1.
If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
If the plug is damaged, pay attention
to the following:
Plugs and sockets situated near the
work site or outdoors should be to
class IP 55 of BS 5490 to provide ad-
equate protection against ingress of
water, etc. and cable entries require
effective sealing. Rubber shrouds
should be provided over cable
glands. Drip-proof (class IP X2 of
BS 5490) plugs and sockets to
BS 4343 are suitable for use indoors
where the plug is away from the water
spray area where the appliance is in
use.
Never touch the mains plug with wet
hands.
Do not pull plug while operating the
device.
Do not run over, crush or pull the
power supply cord or extension cord,
otherwise it may be damaged. Pro-
tect the cable from heat, oil and sharp
edges.
Do not use the unit, if the power sup-
ply cord or important parts, e. g.
F 016 L81 747 | (7.8.17)
high-pressure hose, power gun or
safety devices are damaged.
Warning: Inadequate extension cords
can be dangerous.
If an extension cord is used, the plug
and socket must be of watertight con-
struction. The extension cord must
have a cross section in accordance
with the operating instructions and
be protected against splashed water.
The connection must not be in water.
When replacing plugs on the power
supply cable or extension lead the
spray water guard and mechanical
stability must remain intact.
Water connection
Comply with the regulations of your
water supply company.
All connecting hoses must have prop-
erly sealed joints.
Make sure that the supply hose is at
least 12.7 mm (1/2") in diameter and
is reinforced.
The appliance should never be used
on the drinking water supply without
a back flow valve. Water which has
passed the back flow valve is regard-
ed as undrinkable.
The high-pressure hose must not be
damaged (danger of bursting). A
damaged high-pressure hose must be
replaced immediately. Only use hos-
es and connections recommended by
the manufacturer.
High-pressure hoses, fittings and
couplings are important for the safety
of the appliance. Use only hoses, fit-
tings and couplings recommended by
the manufacturer.
Bosch Power Tools

Publicidad

loading

Este manual también es adecuado para:

Easyaquatak 120