Bort BWS-1405-R Instrucciones De Servicio página 5

English
Angle polisher
TECHNICAL SPECIFICATIONS
PRODUCT ELEMENTS
1. Spindle-lock button
2. Auxiliary handle
3. On/off locking switch
4. Switch locking knob
5. Speed adjustment wheel
SAFETY
WARNING! Read all instructions. Failure to follow all
instructions listed below may result in electric shock,
fi re and/or serious injury.
• This tool should not be used by people under the
age of 16 years
• Always disconnect plug from power source before
making any adjustment or changing any accessory
ACCESSORIES
• Use the original SBM Group accessories which can
be obtained from your SBM Group dealer
• For mounting/using non- SBM Group accessories
observe the instructions of the manufacturer con-
cerned
• Use only accessories with an allowable speed
matching at least the highest no-load speed of the
tool
OUTDOOR USE
• Connect the tool via a fault current (FI) circuit break-
er with a triggering current of 30 mA maximum
• Only use an extension cord which is intended for
outdoor use and equipped with a splashproof cou-
pling-socket
BEFORE USE
• Before using the tool for the fi rst time, it is recom-
mended to receive practical information
• Use completely unrolled and safe extension cords
with a capacity of 16 Amps (UK 13 Amps)
• Wear protective glasses and gloves, hearing protec-
tion and sturdy shoes; when necessary, also wear
an apron
• Be sure tool is switched off when plugging in
DURING USE
• Always keep the cord away from moving parts of the
tool; direct the cord to the rear, away from the tool
• If the cord is damaged or cut through while working,
do not touch the cord, but immediately disconnect
the plug; never use the tool with a damaged cord
• Push spindle-lock button only when spindle is at a
standstill
• Keep hands away from rotating accessories
1
2
• In case of electrical or mechanical malfunction,
immediately switch off the tool and disconnect the
plug
• In case of current interruption or when the plug is
accidentally pulled out, unlock the on/off switch im-
mediately and put it in the OFF-position in order to
prevent uncontrolled restarting
• Do not apply so much pressure on the tool that it
comes to a standstill
AFTER USE
• Before you put down the tool, switch off the motor
and ensure that all moving parts have come to a
complete standstill
• After switching off the tool, never stop the rotation of
the accessory by a lateral force applied against it
WHEN CONNECTING NEW 3-PIN PLUG
(U.K. ONLY):
• Do not connect the blue (= neutral) or brown (= live)
wire in the cord of this tool to the earth terminal of
the plug
• If for any reason the old plug is cut off the cord of
this tool, it must be disposed of safely and not left
unattended
Your machine is double insulated in accordance with
EN 50144; therefore no earthwire is required.
MAINTENANCE
Make sure that the machine is not live when carrying
out maintenance work on the motor.
Regularly clean the machine housing with a soft cloth,
preferably after each use. Keep the ventilation slots
free from dust and dirt.If the dirt does not come off use
a soft cloth moistened with soapy water. Never use
solvents such as petrol, alcohol, ammonia water, etc.
These solvents may damage the plastic parts.
The machine requires no additional lubrication.
Should a fault occur, e.g. after wear of a part, please
contact your local SBM Group dealer.
ENVIRONMENT
In order to prevent the machine from damage during
transport, it is delivered in a sturdy packaging. Most of
the packaging materials can be recycled. Take these
materials to the appropriate recycling locations. Take
your unwanted machines to your local SBM Group
dealer. Here they will be disposed of in an environmen-
tally safe way.
GB
7 7