Ryobi RY31SC312 Guia Del Usuario

12 in. Surface Cleaner Attachment
RY31SC312
WARNING:
To reduce the risk of injury, user must read and understand the opera-
tor's manual for their pressure washer before using this accessory. To
reduce the risk of injury or property damage, spray the pressure stream
in a safe direction to ensure proper connection of all accessories before
starting any cleaning project. Only use on pressure washers operat-
ing at up to 3,100 psi with a maximum flow rate of 1.2 gpm. Ensure
compatibility and proper fit before using this accessory. Wear eye
protection with side shields marked to comply with ANSI Z87.1. Risk
of fluid injections; do not point at people, pets, electrical devices or
the unit itself. Turn off the pressure washer, relieve the water pres sure
in the trigger handle, and lock the lock out on the trigger handle (if one
is included with your pressure washer) before installing, changing, or
adjusting accessories. For cold water use only. For outdoor use only
– store indoors. Save these instructions. Refer to them frequently and
use them to instruct other users. If you loan someone this tool, loan
them these instructions also.
PRODUCT SPECIFICATIONS
Connections ....................................... 1/4 in. Quick Connect Plug
Deck Width ............................................................................12 in.
Maximum Pressure ................................................ up to 3,100 psi
Maximum Water Flow ....................................................... 1.2 gpm
Maximum Inlet Water Temperature ...................................... 140°F
INSTALLING THE CASTERS
See Figure 1.
n Carefully turn the tool upside down.
n Push casters into the grommets located at the base of the
surface cleaner until they are securely in place.
n Make sure the casters are secure, and then return the tool to
the upright position.
INSTALLING THE SURFACE CLEANER ON THE
SPRAY WAND
See Figure 2.
n Pull back the quick-connect collar on the pressure washer spray
wand.
n Insert the surface cleaner inlet plug into the spray wand quick
connect coupler.
n Push the collar forward so that the surface cleaner inlet plug is
secured properly. Check to see that the connection is secure.
WARNING:
To reduce the risk of injection or injury, only use the surface cleaner on
flat, horizontal surfaces. Never lift the surface cleaner from the cleaning
surface while operating the pressure washer.
USING THE SURFACE CLEANER
See Figure 3.
WARNING:
Do not reach hands or feet under cleaning deck. Contact with the
spinning nozzles or spray bar can result in a fluid injection or other
serious personal injury.
CASTERS
QUICK CONNECT COUPLER
INLET
PLUG
Fig. 1
Fig. 2
Fig. 3