Klarstein BOTELLA 120S Manual Del Usuario página 29

ADJUSTING & REMOVING THE SHELVES
For easy access to the storage content, you must pull the shelves approximately 1/3 of
its depth out of the rail compartment. These wine cabinets, however, are designed with a
notch on each side of the shelf tracks to prevent bottles from falling. When removing any
of these shelves out of the rail compartment, tilt the shelf as per the diagram and simply
pull out, or push in the shelf until it sits on the support brackets securely.
Common wooden shelf:
1. According to right instruction drawing to press one side of shelf limit pin (1), extract
and remo- ve the shelf from the other side of support bracket (2), then take off the
shelf following the arrow mark (3).
2. Shelf installation will be opposite with shelf taking.
Sliding wooden shelf installation and taking instruction:
• Shelf taking: According to below instruction drawing to pull out the shelf to support
bracket , press two sides of sliding roller buckles and pull out the shelf following the
arrow mark (1).
• Shelf installation: According to below instruction drawing to push in the shelf
alignment with two sides of sliding roller following the arrow mark (2).
EN
29