Publicidad
ASSEMBLY ESCOOTER INSTRUCTION
1. Lift the steering wheel up and fasten the securing element.
2. Even without the front wheel, install the front fender.
3. Install the front wheel with the brake disc using the front axle with a latch.
4. Install the steering crossbar.
5. The last step is to adjust and tighten the front lighting.
CHARGING METHOD
1.
Connect the charger is located at the left side of
the vehicle (see figure).
2.
Connect the charger cable to the hole (make sure
that the components are dry).
3.
The charger light will light up in red during charging.
When the color will change to green, the battery
is fully charged and you should disconnect the
charger, otherwise it will have a negative impact on the battery life.
4.
Finish charging by covering the charging port, to protect it from moisture.
CHARGING SAFETY TIPS
If the battery will not charge at the right time, can cause damage. Full battery discharge risk
reduction of its viability.
Please use only original batteries, chargers and cables, it is necessary to protect the battery
from overcharging.
Please make sure that the charger cables have been properly connected and charging is
done in a well ventilated environment.
The charger should be used in a dry environment. Charger and cables must be protected
from contact with water, because there is a risk of electric shock. Do not touch the device
with wet hands. If any error occurs while charging, disconnect the charger from the power
supply.
When disconnecting the charger from the power supply depends on the pull by the plug,
not the cord.
Do not allow to contact the charger and cables with sharp or hot objects.
– EN
MES2003J
CHARGING
9
Publicidad
