Publicidad
Idiomas disponibles
Idiomas disponibles
9 INSTALL MOUNTING SCREWS
WARNING
Mounting screws must be used.
Failure to do so could result in the oven falling out of
the cabinet, causing serious injury.
NOTE: Before drilling the pilot holes, make sure the
oven is pushed as far back into the opening as it will
go and is centered.
A. Tip the top of the oven toward you so the bottom of
the unit can slide into the cutout first.
B. Slide the oven the remaining way into the opening
so that the side flanges and control panel are against
the cabinet frame. Make sure that the oven is
centered in the opening.
C. Open the door, place a rack in the oven and make
sure that the rack in the unit is level.
D.
Drill pilot holes through the side flanges into the
cabinet.
E. Place the included washers around the mounting
screws and drive the screws into the side flanges. It
is recommended that the screws
be hand tightened.
12
Installation Instructions
10 REPLACING THE OVEN DOOR
NOTE: The oven door is heavy. You may need help
lifting the door high enough to slide it into the hinge
slots. Do not lift the door by the handle.
A. Lift the oven door by grasping
each side.
B. With the door at the same
angle as the removal position
(approximately 1"–2" [2.5 cm–5.1
cm] from the closed position),
seat the notch of the hinge arm
into the bottom edge of the hinge
slot. The notch of the hinge arm
must be fully seated into the
bottom of the slot.
C. Fully open the door. If the door will not fully open,
the indentation is not seated correctly in the bottom
edge of the slot.
D. Push the hinge locks up against the front frame of
the oven cavity, to the locked position.
Hinge in
Locked
Position
Notch of Hinge
Securely Fitted
Into Bottom of
Hinge Slot
E. Replace hinge bracket, if
equipped, to ensure proper door
functionality.
F. Close the oven door.
Hinge
Bottom
Arm
Edge of
Slot
Hinge Notch
Hinge Bracket
31-2000694 Rev. 2
Publicidad
