Publicidad
Idiomas disponibles
Idiomas disponibles
2 G CUTOUT FOR STEAM OVEN
BESIDE ANOTHER BUILT-IN STEAM
OVEN/BUILT-IN SPEEDCOOK OVEN:
25-1/4
17-1/2
Steam Oven
If you are mounting a Built-In Steam Oven beside a
Built-In SpeedCook Oven or another Built-In Steam
Oven, use the dimensions shown. The middle rail
separating the two openings may need to be larger
than the 4-1/2 minimum shown.
When installed beside a Built-In SpeedCook Oven
or another Built-In Steam Oven: Steam ovens are
suitable for installation under only certain specified
appliance models. See the label attached to the
outside of the steam oven for suitable models.
8
Installation Instructions
23-1/2
25-1/4
17-1/2
Steam Oven
4-1/2" Min.
(5-1/2" Recommended)
3 DOOR REMOVAL
NOTE: Door removal is not a requirement
for installation of the product but is an added
convenience.
To remove the door:
A. Open the oven door as far as it will go.
B. Remove hinge bracket, if equipped,
from front frame and set aside.
The hinge bracket must be
replaced, if equipped, for proper
door functionality when door is
reinstalled.
C. Push both hinge locks down toward
the door frame to the unlocked
position. This may require a flat-
blade screwdriver. DO
NOT LIFT THE DOOR BY
THE HANDLE!
Hinge Slot
D. Place hands on
both sides of the door
Hinge Arm
and close the oven
door to the removal
position (approximately 1"–2" [2.5 cm–5.1 cm] from
the closed position).
E. Lift the door up and out until the hinge arms clear
the slots. NOTE: The oven door is very heavy. Be
sure you have a firm grip before lifting the oven
door off the hinges. Use caution once the door is
removed. Do not lay the door on its handle. This
could cause dents or scratches.
Hinge Clears Slot
Hinge Bracket
Hinge Unlocked
Position
31-2000694 Rev. 2
Publicidad
