Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL THE D UCTWORK
NOTE: The duct connector has a counter-balanced damper
flap. The flap will be "open" approx. 1" when duct connector
is attached to housing. This design permits insulation to be
in direct contact with fan/light housing per UL (Underwriters
Laboratories) standards. The slightest backdraft, however,
will close the damper flap, preventing air from entering unit
or finished space.
1. Snap the damper/duct connector onto housing. Make sure
that tabs on the connector lock into slots in housing. Top of
damper/duct connector should be flush with top of housing.
2. Connect 4" round duct to damper/duct connector and
extend duct to outside through a roof or wall cap. Check
damper to make sure that it opens freely. Tape all duct
connections to make them secure and air tight.
CONNECT THE WIRING
SCHEMATIC WIRING DIAGRAM
L I G H T
S W I T C H
V E N T
S W I T C H
B L K
L I N E
W H T
I N
G R D
S W I T C H B O X
BLACK
WHITE
BLUE
DUAL CONTROL
(purchase separately)
SWITCH BOX
LIGHT
FAN
120 VAC
LINE IN
1. Wire unit following diagram above. Run electrical cable as
direct as possible to unit. Do not allow cable to touch sides
or top of unit after installation is complete.
FLUSH
R E D
B L U
W H T
L I G H T
( W H I T E )
B L K
B L K
W H T
V E N T
( B L A C K )
W H T
G R D
U N I T
WHITE
RED
RECEPTACLE
(LIGHT)
GROUND
(bare)
WIRING
PLATE
ATTACH THE GRILLE PAN AND
GLASS SHADE
LOCK WASHER
GLASS SHADE
GRILLE
PAN
1. Locate the grille pan over the fan housing and connect the
wiring harness plug into white receptacle in the fan housing.
2. Insert rod through center hole of grille pan. Use lock washer
between collar on rod and pan.
BLACK
3. Thread rod onto grille screw in housing, until pan is tight
RECEPTACLE
(FAN)
against ceiling. Do not over-tighten mounting rod.
4. Install bulbs. Use 13-watt (maximum), GU24 base, fluorescent
bulbs with a M.O.L. (maximum overall length) of 4.8 inches
or less.
5. Place washers and glass shade over mounting rod and align
shade over grille pan. Secure glass shade to mounting rod
with felt washer and finial nut as shown.
6. Restore electrical power and check operation of the unit.
MODEL 773BNNT
GRILLE SCREW
GRILLE PAN
COLLAR
ROD
FELT WASHER
FLUORESCENT
LOCK
WASHER
ROD
STEEL WASHER
GLASS
SHADE
FELT
WASHER
(Add second
washer as
needed to
secure shade
tightly.)
FELT
FINIAL
WASHER
NUT
Page 3
WASHERS
13 WATT
MAX.
GU24 BASE
BULBS
(2 REQ.)
Publicidad
