GE DBVH510 Manual Del Propietário página 13

STEP-BY-STEP INSTRUCTIONS (cont.)
Remove Hinge
IMPORTANT: Note the location of the hinge (left or right) before removing.
8. With the door frame part of the door laid down on a protected soft surface,
9. Remove the 2 nuts, washers and the 2 machine screws (#8).
10. Remove the hinge assembly by removing the 2 machine screws (#8) that
Reinstall Hinge Assembly
11. Place the hinge assembly in the opposite side of the door. Align the hinge
12. Loosely fasten the hinge assembly to the edge using 2 machine screws (#8).
13. Hold the door on its side with one hand and fasten the remaining 2 screws
remove the hinge cover by removing the 2 tapping screws (#8) that fasten it
to the frame. The hinge cover is located at the opposite side of the hinge
assembly.
fasten it to the frame. Pull the hinge assembly out and set it aside.
holes with the door holes.
as shown. Then tighten the 2 screws (#8) holding the hinge assembly.
ge.com
13