Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION - General
The appliance is intended only for
domestic use, not for professional
use.
1. Permanent filter
2. Filter holder
3. Pause-and-serve function
4. Swivel filter holder
5. Release button
6. Thermal carafe
7. Measuring spoon
8. Water reservoir
9. Water-level indicator
10. Coffee maker housing
11. Power chord and plug
12. Start button with control light
OPERATION - Before first use
Clean the appliance a couple of times by filling it with water only. Please observe the
following instructions. Dispose of the water after use.
OPERATION - Making coffee
1. Place the appliance on a flat and steady surface. Remove the thermal carafe (6).
2. Open the lid of the water reservoir (8). Pour sufficient water into the reservoir (not less than 2 cups and
not more than 8 cups, as shown on the water-level indicator (9).
3. Open the filter holder (4) by pulling the handle towards you. Use the permanent filter (1) or put a
paper filter (1 x 4) in the filter holder. Fill the paper filter with the required amount of ground coffee (the
customary quantity is 1 level scoop (7) for each cup). Close the filter holder by pushing the handle back
until it clicks into place.
4. Place a thermal carafe back.
5. Connect the plug (11) to the wall socket. Switch on the appliance by pushing the start button (12). The
control light will now illuminate and the coffee will be prepared.
6. The pause-and-serve (3) function enables you to pour a cup of coffee before the coffee maker has finished.
Replace the carafe quickly, to prevent the filter from overflowing.
7. The coffee machine automatically stops when the brewing is done. If you wish to halt the brewing
prematurely, you can push the start button again. The control light will extinguish.
8. Remove the plug from the wall socket.
WARNING:
•
Allow the appliance to cool down before using it to brew additional coffee!
1
2
3
4
5
6
21
EN
7
8
9
10
11
12
Publicidad
