Ryobi GD200A Manual Del Operador página 45

INSTALLING ACCESSORIES
See Figures 78 and 79.
The garage door opener can power a variety of AC and
DC accessories. For a complete list of accessories, visit
www.ryobitools.com.
WARNING:
Use only recommended accessories listed on our
website, in this manual, or in addendums. Use of
accessories that are not listed may cause the risk of
personal injury. Instructions for safe use of accessories
are included with the accessory.
WARNING:
Ensure accessories are properly and securely connected
to their port on the garage door opener. Failure to
properly secure the accessory can cause it to fall and
could result in serious personal injury or property damage.
For DC accessories:
 Select one of the accessory ports to power your DC
accessory.
 Hook the accessory to the top of the garage door opener
and insert it into the accessory port. Ensure the bottom
latch on the accessory is secured to the port on the
garage door opener.
NOTE: DC accessories will not receive power unless the
accessory port has been activated. See Using the Indoor
Keypad later in this section.
 Depress latches to release and remove the accessory.
For AC accessories:
 Remove both accessory port covers on the side where
you will install the accessory.
 Insert AC accessory into the AC receptacle as shown.
 Secure the accessory in place by hooking it to the top of
the garage door opener and ensure the bottom latch on
the accessory is secured to the port on the garage door
opener.
OPERATION
 Depress latches to release and remove the accessory.
NOTE: If the garage door opener is unplugged and a charged
battery pack is installed, the AC receptacles and accessory
ports will be disabled but the sensors and LED lights will
continue to function normally.
Accessory
Port # 1
45 - English
Hooks
Latch
Hooks
Latches
AC
Receptacle
DC
Accessory
Fig. 78
AC
Accessory
Fig. 79