Publicidad
Idiomas disponibles
Idiomas disponibles
Self-cleaning
• When the vacuum is charging and its battery level is equal to or more than 10%, press
start self-cleaning.
• Press the button
or the button
to stop self-cleaning.
• Based on how dirty the roller brushbar is, it will take about 2 to 3 minutes for the vacuum to
complete the self-cleaning.
Notes:
• Clean the dirty water tank in time after self-cleaning to prevent odors.
• It is recommended to remove the roller brushbar after self-cleaning and place it in the accessory
container for drying to prevent odors.
• It is recommended to regularly clean parts that cannot be cleaned by self-cleaning, such as the
roller brushbar cover and the parts around the suction port.
Care & Maintenance
to
CAUTIONS:
• Clean and maintain the relevant components when the vacuum is paused in the upright position
or turned off.
• Move the self-cleaning charging dock away before cleaning the vacuum.
Maintenance Frequency
Component
Dirty water tank components (including the dirty water tank,
the dust compartment, and the water level sensor)
Dirty water outlet pipeline (including the dirt
detection sensor)
Water & Air Separator
Floor brush (overall)
Roller Brushbar
Filter
Self-cleaning Charging Dock
Replacement Frequency
Note:
The following recommended replacement frequencies are for reference only. Components
should be replaced promptly if damaged.
Component
Roller Brushbar
Filter
12
Recommended
Maintenance Frequency
Clean after each use.
Clean when prompted by
relevant voice notification.
1–3 months
Clean once a week, depending
on the dirtiness.
Self-cleaning is required after
each use.
Clean it monthly.
Clean once a week.
Recommended Replacement Frequency
3–6 months
6–12 months
Publicidad
