OSOTEK H200 Manual De Instrucciones página 7

Installing the Handle
Insert the handle upright into the main unit until you hear a click, which indicates that
it is locked. Then reconfirm that it is secured in place.
Removing the Handle
Use a non-sharp tool to hold down the handle release button on the back of the main
unit, while pulling the handle upright.
Click
Removing the Handle
Installing the Self-cleaning Charging Dock
1. Installing the Power Cord
Plug the power cord into the power port at
the bottom of the self-cleaning charging
dock, then wind and store the excess power
cord.
3. Installing the Accessory Container
Install the accessory container onto the
mounting clip.
6
2. Installing the Mounting Clip
Install the mounting clip onto the
installation slot on either side of the bottom
of the self-cleaning charging dock.
4. Storing the Accessories
The container can store the cleaning brush,
the roller brushbar, and the filter.
Note: The spare roller brushbar and
the spare filter need to be purchased
separately.