Publicidad
Idiomas disponibles
Idiomas disponibles
3. Release the valve by rotating it counter-clockwise
(see figure 3) and clean it carefully.
4. Use a damp sponge or soft cloth with a neutral
soap or detergent. Rinse thoroughly and make
sure no soap residue is left behind. Finally, dry
with a clean, soft cloth.
NOTE: Do not use coarse fibers to clean the water
storage tank, as this can damage the finish.
IMPORTANT: Before reattaching the storage tank to the door,
make sure that:
•
The valve has been properly attached.
Make sure the valve stop is making
contact with the stop located on the
storage tank.
•
And also make sure that the isolation ring
is properly placed on the tank, as shown
in the following figure.
To reattach the storage tank to the refrigerator door:
1. Attach the valve to the tank by rotating it clockwise, insert the
tank cover lid strap and reposition the cover.
2. Finally, use both hands to reattach the tank to the door, tilting
it slightly upward. Secure it to the side brackets on the inside
of the door and push down until it fits firmly in place.
NOTE: Make sure the storage tank has been correctly secured to
the door, and that there is no chance it will fall.
How to use the refrigerator with
electronic control
Temperature Control
Your refrigerator is equipped with a smart temperature control.
You can use it to set the refrigerator compartment temperature
as needed.
To set the refrigerator compartment temperature:
The product is set to the recommended temperature at the
factory. To adjust that temperature, simply press the
This will decrease product temperature. The setting change is
unidirectional, from Cold to Coldest (left to right). Once the control
is in the Coldest position, it will move back to the least cold setting
(Cold) if pressed again.
Figure 3.
Remove the entire glass or wire shelf
Position the refrigerator shelves according to what you want to
store in the refrigerator.
To remove the shelves:
1. Remove all the items from the shelves.
2. Lift up the back part of the shelf.
3. Slide the shelf out.
To replace the shelves:
1. Place the back part of the shelf over the rails on the sides of
the refrigerator cavity.
button.
2. Guide the front part of the shelf onto the rails.
3. Slide the shelf fully in.
11
■ This is the coldest temperature
(Coldest) in the product. All the
indicators will be on.
■ The least cold temperature
setting will be displayed
with the first indicator
(left to right) on.
■ The median minimum
temperature will be displayed
when you press the
button
once from the least cold
temperature. The first and
second indicators will be on.
■ The recommended temperature
will be displayed with the
second indicator on.
■ The median minimum
temperature will be displayed
when you press the
button
once from the recommended
temperature. The second and
third indicators will be on.
■ The cold temperature will be
displayed when you press
the
button once from the
median temperature. The third
indicator will come on.
Publicidad
