Perel LEDA3001RGB Manual Del Usuario página 7

 Overhead mounting requires extensive experience: calculating
workload limits, determining the installation material to be used...
Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these
qualifications as improper installation may result in serious
injuries.
 This device is not suitable for dimming.
Distances
 Keep at least 50 cm distance at the top and 30 cm on either side.
 Respect a minimum distance of 1 m between the device's light
output and any illuminated surface.
Mounting the lamp
1. This luminaire does not have a built-in device to disconnect it
from the electric mains. Make sure to electrically isolate the
luminaire before installation or maintenance activities are
performed.
2. Use the mounting bracket [1] to determine the location of the
mounting holes.
3. Drill the holes and secure the bracket using screws and wall
plugs.
4. Connect the power cable to a suitable junction box (not incl.).
Make sure the connection is properly earthed. Make sure there is
no strain on the cable; leave sufficient slack.
V. 03 – 12/11/2015
LEDA3001RGB
N = neutral, blue
E = earth, yellow/green
L = line, brown
7 ©Velleman nv