Descargar Imprimir esta página

Philips AZ1015 Manual De Instrucciones página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
Under no circumstances should you try
to repair the set yourself as this will
invalidate the warranty.
Problem
Possible cause
No sound,
VOLUME is not adjusted.
no power
Headphones are connected.
Power cord is not securely connected.
Batteries are dead.
Batteries are inserted incorrectly.
Trying to change over from AC power to battery
supply without removing the power cord.
No reaction to
Electrostatic discharge.
operation of any keys
Poor radio reception Weak radio signal.
Interference caused by electrical equipment
like TVs, computers, engines, etc.
no or E indication
The CD is badly scratched or dirty.
No CD is inserted.
The CD is inserted upside down.
The laser lens is steamed up.
The CD skips tracks The CD is damaged or dirty.
SHUFFLE
Poor cassette
Dust and dirt on the heads, capstans, or
sound quality
pressure rollers.
Use of unsuitable cassette types
(METAL or CHROME) for recording.
Recording does
Cassette tab(s) may be snapped off.
not work
Remote control does Batteries are inserted incorrectly.
not function properly Batteries are dead.
Distance to the set is too large.
or
is active.
PROGRAM
TROUBLESHOOTING
If a fault occurs, first check the points listed
below before taking the set for repair.
If you are unable to solve a problem by
following these hints, consult your dealer or
service center.
Solution
Adjust volume.
Disconnect headphones.
Connect the power cord properly.
Insert fresh batteries.
Insert batteries correctly.
Remove the power cord from the
unit's AC MAINS socket.
Disconnect the set from power supply,
reconnect after a few seconds.
Adjust the antenna for optimum
reception.
Keep the radio away from electrical
equipment.
Replace or clean the CD.
Insert a CD.
Insert CD with label facing up.
Wait until the lens has cleared.
Replace or clean the CD.
Switch off
SHUFFLE
Clean heads, capstans, and pressure
rollers.
Only use NORMAL type cassettes for
recording.
Apply a piece of adhesive tape over
the opening.
Insert batteries correctly.
Insert fresh batteries.
Reduce distance.
or
.
PROGRAM
15

Publicidad

loading