Publicidad
Idiomas disponibles
Idiomas disponibles
5. Install the upper shelf as shown in Figure 2. Tighten all hardware.
M6 X 16 BOLT (10)
TANK BRACKET (1)
FTG600-23
FIG 2
6. Install the lower shelf as shown in Figure 2. Tighten all hardware. Note: Lower shelf has extra holes for the tank bracket. Shelf
must be oriented so that the tank bracket is on the side of the stove with the regulator hose.
7. Install the tank bracket as shown in Figure 2. Tighten all hardware.
8. Install the leveling feet as shown in Figure 2. (Note: The leveling feet can be adjusted later to level the grill)
9. Install the wheels as shown in Figure 3. Tighten the axle bolt.
AXLE BOLT (2)
FTG600-20
CART WHEEL CAP (2)
CCH-27
FIG 3
10. Install the wheel cap as shown in Figure 3.
11. Stand the grill upright.
12. Install rear leg bracket as shown in Figure 4.
10
LEVELING FOOT (2)
FTG600-17
LOWER SHELF (1)
FTG475-1
UPPER SHELF (1)
FTG475-2
CART WHEEL (2)
CCH-25
FIG 4
REAR LEG BRACKET (1)
FTG475-3
M6 FLAT WASHER (4)
M6 X 16 BOLT (4)
13. Install the 4 shelf brackets as shown in Figure 5. (Note: Leave the bolts a little loose until the shelves are installed.
14. Install handles to shelves as shown
15. Install the side shelves by inserting hook over the bottom rod on the brackets. Lift shelf up and rotate into upper rod. Press
shelf down to lock into position. See Figure 6.(Note: The shelf with the grease cup bracket on the side must be installed on the
left side of the grill.)
GREASE CUP BRACKET
16. Tighten the shelf bracket screws installed in Step 13.
GRIDDLE (1)
FIG 7
FTG475-5
17. Install the griddle in Figure 7.
M6 X 16 BOLT (8)
SHELF BRACKET (4)
CCH-6
SHELF LEFT (1)
SHELF RIGHT (1)
FTG600-3
FTG600-4
FIG 5
FIG 6
11
Publicidad
