Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 5
Thatch collection bag
Mounting hook
Removing + Emptying the Thatch
Collection Bag
Empty the thatch collection bag frequently during use. Do not
wait until it is completely full. We recommend emptying it when
it is half full.
NOTE: A full thatch collection bag will reduce the performance
of this product.
1. Lift the thatch ejector flap and pull the thatch collection
bag off the mounting hooks to remove it.
2. Empty the bag's contents into a suitable waste receptacle.
Mount the bag back into position before resuming work.
Intended Use
1. This scarifier + dethatcher is designated with a 600
watt motor. Depending on the fitted cutting device, this
machine is either intended for scarifying and removing
thatch from lawns or raking in domestic and hobby
gardens.
2. When used as a scarifier, this machine works by
scratching through and between the grass with specially
adapted prongs that collect and remove any unwanted
parts from the lawn while leaving the grass blades intact.
At the same time the machine scarifies the ground
resulting in a better aeration.
3. When used as a dethatcher the fine needles will scratch the
surface of the lawn while simultaneously picking up light
debris for better oxygen absorption, airing and drainage.
4. This machine is not to be used in wet weather conditions
and may not be used to mow dry, wet or unusually high
grass, e.g., pasture grass or for shredding leaves.
5. This machine is intended for private domestic use only,
not for any commercial trade use. It must not be used for
any purposes other than those described.
Ejector flap
12
Operation
Cutting Depth Adjustment
m
WARNING!
Turn off the unit and remove the batteries
before adjusting the tine settings.
Adjust the depth according to the needs of your lawn. The
most suitable depth depends on the kind of lawn and the
actual height of the grass.
The scarifying/raking depth is controlled by one system. Follow
the instructions below to adjust the scarifying or raking depth.
1. To adjust the scarifying/raking depth, push inside the
knob lock and turn the scarifying/raking depth adjustment
knob at the same time. Rotate the knob until the indicator
on the knob aligned with the mark around the knob
(1/2/3/4/5) (Fig. 6).
Fig. 6
Knob lock
2. This scarifier + dethatcher is equipped with 5 scarifying/
raking depths. When assembled with different cylinder,
each setting indicates different depth. Check the table
below for details about each setting.
Position
Scarifying Depth
1
5 mm
2
-0.5 mm
3
-6 mm
4
-8.5 mm
5
-9.5 mm
Scarifying/raking
depth adjustment
knob
Raking Depth
10 mm
4.5 mm
-1 mm
-3.5 mm
-4.5 mm
Publicidad
