Telcoma Automations E224 Manual De Instrucciones página 45

Idiomas disponibles

ADVANCED PROGRAMMING (manual)

This type of programming procedure enables the user to manually enter the leaf delays and deceleration points.

Procedure:

Follow points 1 to 10 of the above paragraph "Automatic programming".

Proceed with the following sequence taking into account that, unlike in the case of automatic programming, this requires a sequence of references in

real time.

11-12- When both leafs are closed, M1 is started up automatically in opening.

13- Press S/S when the leafs reach the required offset (in opening). To indicate and confirm recording, motor M1 stops for a few seconds and then

restarts in opening.

14- Press S/S when the leaf with M1 reaches the (required) deceleration zone. To indicate and confirm recording, motor M1 stops for a few seconds and

then restarts in opening.

15-16- When M1 reaches the end stop (or limit switch) on opening, M2 starts up automatically in opening.

17- Press S/S when the leaf with M2 reaches the (required) deceleration zone. To indicate and confirm recording, motor M2 stops for a few seconds and

then restarts in opening.

18- When the two leafs are both in the open position, the pause time memorisation phase is started.

19- Once the required pause interval has elapsed, press the S/S button and motor M2 starts closing.

20- Press S/S when the leafs reach the required offset (in closing). To indicate and confirm recording, motor M2 stops for a few seconds and then

restarts in closing.

21- Press S/S when the leaf with M2 reaches the (required) deceleration zone. To indicate and confirm recording, motor M2 stops for a few seconds and

then restarts in closing.

22- When M2 reaches the end stop, M1 closes.

23- Press S/S when the leaf with M1 reaches the (required) deceleration zone. To indicate and confirm recording, motor M1 stops for a few seconds and

then restarts in closing.

24- Gate completely closed

25- End of programming (the control unit sets automatically to normal operating mode).

- The memorised values remain stored until a new programming cycle is performed.

PAUSE

Time

LD3

End