Profi Cook PC-WC1046 Instrucciones De Servicio página 75

• Only install at a location with an ambient temperature suitable for the climate class
of the device.
For information on the climate class, please refer to chapter "Specifications" or to
the rating label located in the interior or on the rear side of the device.
• Avoid installation at locations with high humidity (e.g. outdoors, cellar, bathroom),
as metal parts would be susceptible to corrosion under such circumstances.
• Do not place the device near volatile or combustible materials (e.g. gas, fuel, alco-
hol, paint, etc.) and in rooms which may have poor air circulation (e.g. garages).
• Only place on a steady and safe surface.
• This appliance is equipped with non-slip rubber feet. As furniture surfaces are
made of a variety of materials and are treated with many different types of cleaning
agents, it cannot be completely ruled out that some of these substances may con-
tain ingredients which could corrode the rubber rests and soften them. If possible
place an antislip material under the feet of the device.
• If the device is not horizontally leveled, adjust the feet accordingly.
Power supply
The kind of current (AC) and the voltage must be conform to the data of the rating la-
bel, located inside or outside on the back of the unit. In case of heavy voltage fluctua-
tions, it is recommended to use an automatic alternating current regulator.
The plug, together with the grounding conductor, must fit into the wall socket. The
mains plug must be freely accessible. The cord should be secured behind the wine
refrigerator and not let exposed or dangling to prevent accidental injury.
S /O
tartUP PeratiOn
Prior to first use
IMPORTANT: Before connecting the appliance to the power source, let it stand
upright for ap-proximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
• Clean the interior of the device including all accessory parts located inside with
lukewarm water and by using a soft cloth.
Connect the device to the mains supply
IMPORTANT
The device must be earthed properly. For this purpose the plug of the
mains cable has been fitted with the intended lead.
IMPORTANT
Contact an electrician if the plug does not fit in the wall socket.
75