Gardenline 43537 Manual Del Usuario página 4

2 Person Swing
C
A
STEP 1: Remove all parts from the box and place them on a non-abrasive surface.
Align the two holes at one end of Top Cross Bar(C) with the two holes in the top
of the Front Leg Tube (A) and the two holes in the top of Back Leg Tube (A) on the
other side. Insert a Bolt (R) through Front Leg Tube (A), Top Cross Bar (C), Back Leg
Tube (A), and into Washer (V), and Nut (U) for each hole. Don't tighten all bolts
until you finish the assembly and cover with Caps (W, Y). See Fig.1. Repeat this step
on the other side of the frame.
5
cs@discoverhomeproducts.com
Assembly Instructions
V
C U
W
Y
R
A
V U W
AFTER SALES SUPPORT
1855 965 5310
USA
USA
2 Person Swing
H
STEP 2: Connect the Top Cross Side Brace (H) and Top Cross Bar (C) with Bolt (P),
Washer (V) and Nut (U). Then connect the Top Side Brace (H) to the Front and
Back Leg Tubes (A) with Bolt (N), Washer (V) and Nut (U) and cover with
Caps (W, Y). See Fig.2.
Y N
STEP 3: Adjust the angle of the two legs. Place a Leg Cross Bar (B) between two
legs on one end of the frame, lining up the bolt holes. For each hole in the front
and back legs, insert Bolt (N), and Washer (V) through the Leg Tube (A) and into
the Leg Cross Bar (B). Do not completely tighten and cover with Cap (Y).
See Fig.3. Repeat this step for the cross bar between the other legs.
AFTER SALES SUPPORT
1855 965 5310
USA
V U W
c
Y P
V U
Y
N
A
Y
A
N V
B
V
USA
Assembly Instructions
W
V U W
B
6
cs@discoverhomeproducts.com