Gardenline 43537 Manual Del Usuario página 6

2 Person Swing
M
V
I
STEP 7: Connect the Canopy Frame Bar (I) and the Canopy Frame (K) with
Bolt (M), Washer (V) and Bolt Cap (Y) as shown in Fig.7.
STEP 8: Put the Canopy Cloth(Q) on the assembled instruction by Step 7.
Then you can stick the velcro as shown in Fig.8.
9
cs@discoverhomeproducts.com
Assembly Instructions
K
Y
V M Y
Caution: The hole above the Canopy
Cloth(K) must aligned with the hole on
Canopy Frame (K).
AFTER SALES SUPPORT
1855 965 5310
USA
USA
2 Person Swing
FIG.9
STEP 9: Screw Knob (T) from outside through the gear hole on the Canopy Frame
(K) and into the gear hole on the Top Cross Bar (C). Repeat this step with the
second knob on the other Side.See Fig.8. Don't tighten completely. You can
change the tilt of the canopy by adjusting the knobs. Make sure that all of the
bolts are securely tighten. Place the Seat Cushion (L) on the seat.
FIG.10
STEP 10: If the canopy is not tighten after assembled, please stick the velcro,
tighten it and glue again until you feel Satisfaction.
Now please enjoy your new 2 person swing.
AFTER SALES SUPPORT
1855 965 5310
USA
Assembly Instructions
Velcro
cs@discoverhomeproducts.com
USA
10