GE PVM1790 Instrucciones De Instalación página 20

C3 ADAPTING BLOWER
FOR RECIRCULATION
NOTE: The exhaust adaptor with damper is not
needed for recirculating models. You may want
to save them for possible future use.
1 Remove and save screws that hold blower plate
to the oven.
Slide the blower plate from under its retaining
2
flange and lift it off. Remove and save screw that
holds the blower motor to oven.
Retaining
Flange
Installation Instructions
Blower Plate Screws
Back of
Oven
Blower Plate
Blower
Motor Screw
Carefully pull out the blower unit. The wires
3
will extend far enough to allow you to adjust
the blower unit.
4
Roll the blower unit 90° so that fan blade openings
are facing toward the front of the oven.
BEFORE: Fan Blade
Openings Facing Up
AFTER: Fan Blade
Openings Facing
Forward
NOTE: Make sure wires remain routed in the grooves
of the motor frame.
20
Roll